In reply to Brian.

Hi Brian, the Tune option should be available during the first layer. After the automatic leveling routine completes, start a test print and open Tune → Z Offset on the screen. Adjust the value in small steps (around ±0.02–0.05 mm) until the filament lays down cleanly without being too squashed or too loose.

Hi Phil,
I have a Creality Ender 3 V3 pro and need some advice on setting up the Z axis. Nowhere can I find values of the Z position to addjust it.
Even after doing all the leveling, etc it still prints the first layer way to flat and hard to get if the bed when finished. Your advice would be much appreciated.
Cheers, Brian.